RCA
RACE8002E-C

How do I change the temperature display from Fahrenheit to Celsius and vice versa?

You can change the display by holding down the “+” and “-“ buttons on the units control panel for three seconds. Note that this can only be done on the unit itself, pressing the buttons on the remote control will not work.

All Freezers

HOW TO DEFROST MY FREEZER:

Manual Defrost Freezer models must be defrosted manually. For best operation, the freezer should be defrosted when the frost accumulation becomes 1/4 to 1/2 inch thick. Below are the instructions for manually defrosting your RCA freezer.

• Turn the temperature control to OFF and unplug the freezer.

• Remove all food and place in corrugated boxes, insulated bags, picnic coolers, etc. Use towels and newspapers for insulation, as needed.

• Remove the drain plug (on models so equipped).

• With the door open, use pans of hot water to speed the loosening of frost. Remove large pieces of frost before they melt.

• Sponge the excess water from the bottom of the freezer as it collects to prevent overflowing.

• After defrosting, clean the inside of the freezer by wiping down with a baking soda and water solution. Rinse and dry.

• Be sure to replace drain cap (on models so equipped). Return the drain tube to its position and replace the grille.

• Plug the freezer in, return the temperature control to the normal position and return food to the freezer.

How to Reduce & Resolve Frost Buildup in Upright Freezers and Freezer Compartments of Two Door Refrigerators.

Frost occurs when moisture in ambient air touches the frozen evaporator coils, metal shelves and interior sides of a freezer.

Steps you can take to reduce frost build up:

Move your hand around the outside of the freezer door. If you feel cold air, then the door is not sealing adequately.

You can adjust the freezer door by loosening the top hinge to reposition/adjust the freezer door to create a tight seal.

Adjust the front levelling feet of your unit such that the front of the unit is slightly higher than the rear. Gravity will assist the freezer door to close with a proper seal.

TIP: Close the freezer door on a dollar bill (or similar). The dollar bill should not easily pull out – there should be some resistance. Perform the “Dollar Bill Test” on the top, sides, bottom of your freezer door, and adjust accordingly.

Do not over fill your freezer to prevent food items from shifting and preventing the freezer door from closing properly.

Place only cool or cold food items in your freezer. Hot foods introduce humidity into the freezer compartment, which contributes to frost build up. Allow hot foods to cool before placing them in the freezer.

Wrap foods tightly with plastic wrap. Butcher paper is not an adequate wrapping material. Glass container lids typically do not provide a proper seal.

Dry the exterior of food before storing. By the time you reach home after purchasing frozen foods, the food items may have defrosted a bit and moisture may have already developed on packaging.

Reduce the amount of time the freezer door remains open. Labelling and organizing your foods so you can easily identify them will help shorten the number and duration of freezer trips.

Set the freezer temperature so the freezers interior compartment stays around 0F (-18C), as higher and lower temperature settings contribute to frost build up.

Door Seal Care:

Keep the door seal clean. You can clean your door seal with a solution of one tsp of baking soda to a quart of lukewarm water. Pour the solution onto a clean sponge, and wipe it over the seal. Sponge off the solution with clear water and dry the seal with a clean cloth before closing the freezer door.

Keep the door seal flexible by lubricating it with some petroleum jelly (e.g. Vaseline). Wipe it on and wipe it off with a clean dry cloth.

All Microwaves

There is a cardboard plate on the inside of my microwave. Am I supposed to remove it?

NO, this cardboard plate is NOT to be removed. It is an airwave guide cover (made from MICA material) that assists the microwave in distributing the heat evenly. Removing this cardboard plate may cause damage to the inner liner of the microwave.

All Fridges

What should be the setting of the fridge at?

The setting should be set at 3 or 4 depending on the external temperature. On a cold day, setting should be set at 4 or 5. As on a hot day, the setting should be lower.

All Microwaves

Where can I purchase a replacement glass tray for my microwave?

Replacement microwave plates can be purchased for $25 from Curtis International Ltd. Please mail a certified check or money order (payable to Curtis International Ltd) to 315 Attwell Drive, Etobicoke, Ontario M9W 5C1, ATTN: Customer Service Department. Make sure to include your name, complete mailing address, phone number with area code, model number and part required.

LOOKING FOR SUPPORT FOR YOUR PRODUCT?

CLICK HERE